CONTACT US | (03) 8786 3335 | info@vibroflow.com.au

Case Study

Crushed Iron Ore Screen

07/07/2016

Case Parameters

General Properties
Equipment Type: Screen
Industry: Mining
Physical Properties
Unit Length: 2929 mm
Unit Width: 894 mm
Unit Height: 2190 mm
Unit Weight: 1200 kg
Application
Capacity: 3 tph
Product Iron Ore
Design
Drive Type: Sub Resonant
Liner Type Bisalloy
Support Type Steel Coil Spring
Trough Construction Mild Steel
Cover Type Quick Release
Motor Quantity 2
Support Location Bottom

Application

As part of an iron ore crushing circuit, any particle over 12mm was required to return for further processing. The entire system was to be designed so that at certain times, the entire screening section can be bypassed.

Dust suppression and removal was a requirement for this project. There was also a requirement for this unit to be serviced by only a single operator.

Solution

A woven wire mesh was chosen as the screening media. This was tensioned using a traditional side clamping system. In this application, the clamps were tightened by bolts instead of hand knobs so that it could be changed by a single person without tools.

Covers were designed so that their weight did not exceed 10kg as to allow a single operator to remove them. They are attached to the trough by a simple quick release system.

Bisalloy liners are located on the bottom of the trough and at the impact deck.

A 200mm extraction spigot is installed on one lid so that all dust can be withdrawn via exhaust.

Contact us for more information

Related Cases

Please choose a related case below. To check out all our cases click here.

Sealed Poly Screen

Vibratory screen with polyurethane screening media and dust tight covers for the recycling industry.

Scalping Screen

Lump removal in a fertiliser plant via direct drive screen.

CnD Finger Screen

Light duty CnD finger screen.

© 2015 | Vibroflow | Australian Engineered and Build Vibratory Equipment

ABN: 67 101 574 476