CONTACT US | (03) 8786 3335 | info@vibroflow.com.au

Case Study

Dust Recovery Feeders

25/01/2013

Case Parameters

General Properties
Equipment Type: Feeder
Industry: Mining
Physical Properties
Unit Length: 2761 mm
Unit Width: 1195 mm
Unit Height: 1109 mm
Unit Weight: 500 kg
Application
Capacity: 5 tph
Product Iron Ore
Design
Drive Type: Direct Drive
Liner Type Polyurethane
Support Type Oscillating Mount
Trough Construction Mild Steel
Cover Type
Motor Quantity 2
Support Location Bottom

Application

A client was losing lots of iron ore product as dust which would then be expensive to clean.

The little space allowed for the project created issues with the installation of traditional dust recovery systems.

Solution

A series of low profile vibratory screens were installed in a series that covered a large surface area. All dust settles on the troughs and is fed into a common receiver that is fed back into the processing system.

Due to the irregular supply of material, a slippery polyurethane wear resistant liner was used on the trough surface. This liner helps eliminate material build up and ensures a smooth discharge.

Motors were specially located on the back of the unit to allow such a low horizontal profile as can be seen in the photos.

Contact us for more information

Related Cases

Please choose a related case below. To check out all our cases click here.

Dust Tight Cement Feeder

Clinker cement vibrating feeders installed in a space restricted tunnel.

Pre Dryer Feeder

6 meter long stainless steel direct drive dryer feeder with covers and oscillating mounts.

Clinker Storage Feeders

Compact feeders for removing dry abrasive clinker from storage.

© 2015 | Vibroflow | Australian Engineered and Build Vibratory Equipment

ABN: 67 101 574 476